79070402010 Kenmore Range Parts List

Light bulb (lamp)

This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Oven rack

The metal chrome oven rack is a genuine OEM part. The oven rack is located inside of the oven cavity to provide a stable surface for cooking or broiling. This rack measures approximately 23” long x 16” wide and is sold individually. If your rack is rusted, damaged or missing you will need to replace the oven rack. No tools are required for this repair.

Oven burner igniter (ignitor)

Probe

Note: Connector could be different than original. If so cut & splice wires together with porcelain wire nuts.

Inner oven door glass panel (oven glass)

This part is the replacement inner oven door glass for your oven. It is made of glass and is approximately 16 inches wide and 7 inches long. The oven door glass allows you to see inside the oven when the door is closed. The main reason to replace the inner oven door glass is if the old glass is cracked, broken, or missing. This part is an OEM part sourced directly from the manufacturer.

Steel washer (washer)

This washer works in conjunction with the oven door handle to secure the oven door together. The washer measures 3/4-inch x 1/4-inch, is made of metal and is sold individually. This is a genuine OEM part.

Safety valve

This safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

Leveling leg assy (level)

The front leveling leg is used to support and level your range. The leveling leg allows you to adjust the height of your range to make the range level. This part is just the leg, the hardware is not included and can be ordered separately. If the leveling leg breaks or can no longer be adjusted, you will need to replace it. This is a genuine OEM part and is sold individually.

Anti-tip kit (anti tip kit)

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in the back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.

Oven door seal with clips (oven door seal)

Also known as gasket.

Screw (screw-8-18x1)

Sold Individually.

Oven light socket (light socket)

The light socket is located inside the oven cavity to provide power to the light while holding the light bulb in place. If the light bulb is not working, the switch might have failed and will need to be replaced. This is a genuine OEM part. Please remember to disconnect power to the oven before starting your repair.

Leveling leg (screw)

Sold Individually.

Back burner (burner)

Handle set (door handle)

Screws are not included.