79071313708 Kenmore Range Parts List

Light bulb (lamp)

This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Igniter/orifice mounting screw (screw)

This part is the igniter/orifice mounting screw for your cooktop or range. It is approximately ½ an inch in length and is made of metal. The mounting screw connects the orifice to the cooktop. If the orifice is loose, or the screw is missing, this is the part that will replace it. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Probe

Note: Connector could be different than original. If so cut & splice wires together with porcelain wire nuts.

Natural gas to liquid propane conversion kit (lp conversio)

This kit is used to convert your appliance to liquid propane. This liquid petroleum gas conversion kit contains seven orifices, each under an inch long.

Front burner igniter/orifice assembly (ignitor)

This igniter and orifice assembly is a legitimate OEM replacement part for your gas stove, and includes the igniter, orifice assembly, and gas tube. This part may need replacing if the igniter fails or the tube is leaking gas. It is a very easy repair. Remove the grates and burners from the range. Unscrew the existing assemblies and pry off the cooktop. Locate the assembly you are replacing and undo the nut holding it in place. Pull out the igniter wire by hand, and install the new one, replacing the rest of the parts in reverse order.

Steel washer (washer)

This washer works in conjunction with the oven door handle to secure the oven door together. The washer measures 3/4-inch x 1/4-inch, is made of metal and is sold individually. This is a genuine OEM part.

Center burner orifice - 9.5k (natural gas orifice)

Safety valve

This safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

Leveling leg assy (level)

The front leveling leg is used to support and level your range. The leveling leg allows you to adjust the height of your range to make the range level. This part is just the leg, the hardware is not included and can be ordered separately. If the leveling leg breaks or can no longer be adjusted, you will need to replace it. This is a genuine OEM part and is sold individually.

Oven door seal with clips (oven door seal)

Also known as gasket.

Sealed burner head - 14k (sealed burner cover)

Black burner cap ki (cap)

This burner cap kit includes 5 black burner caps. The caps sit on top of the burner head. This part helps spread out the burner flame for even heating and protects the burner head from spills.

Screw (screw #8-18)

Sold Individually.

Oven light socket (light socket)

The light socket is located inside the oven cavity to provide power to the light while holding the light bulb in place. If the light bulb is not working, the switch might have failed and will need to be replaced. This is a genuine OEM part. Please remember to disconnect power to the oven before starting your repair.

Rear burner igniter/orifice assembly (ignitor orifice)