79096008806 Kenmore Range Parts List

Oven bake element (element)

The bake element is located on the bottom of the oven cavity to supply heat for baking. The element terminals are male quarter inch spade connectors and have push-on wire terminals. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.

Infinite burner switch (infinite large element switch)

This surface burner switch controls the stove top 8-inch surface burner temperature. This switch is 240-volt, 2100-2600 watt, and 8.8-10.8 amp. If your element is not defective but will not heat, you may need to replace the switch. This burner switch is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.

Handle mounting screw (screw)

This handle mounting screw works with your oven or range, and bolts the door handle to the door. It is approximately 2 inches in length and is an OEM part sourced directly from the manufacturer. If your oven door will not close or your door handle is loose or disconnected, you may need to tighten or replace the handle mounting screw.

Light bulb (lamp)

This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Temperature sensor (probe)

This temperature sensor detects the temperature within the oven cavity.

Lens

This is an oven bulb lens cover. It is made of glass and is approximately 3 inches in diameter. The lens cover protects the light bulb from being damaged. The main reason to replace the light lens cover is if it is cracked, damaged, or missing. Make sure the lens cover is cool to the touch before you begin this repair. To remove the lens cover, simply turn it counter clockwise until you can remove it. Replace it with a new cover and turn it clockwise to lock it into place. This is an OEM part sourced from the manufacturer, and it is sold individually.

Glass

This is also called the heat barrier glass.

Metal rack (rack)

This is a genuine oven rack, which works with ranges.

Drawer glide (rear door glide)

Sold Individually.

Light lens indicator (lamp lens)

Door top trim (cap)

This is the part the handle screws into for installation.

Leveling leg assy (level)

The front leveling leg is used to support and level your range. The leveling leg allows you to adjust the height of your range to make the range level. This part is just the leg, the hardware is not included and can be ordered separately. If the leveling leg breaks or can no longer be adjusted, you will need to replace it. This is a genuine OEM part and is sold individually.

Screw (screw #8-18)

Sold Individually.

Glide

Light indicator - 125v (indicator lamp)