79572034110 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Mullion spring (spring)

This spring is located on the mullion, or door flap, of your fridge. This spring is sourced from the genuine OEM manufacturer for various refrigerator models. It measures about 1.5 inches in total length, and is made entirely out of metal.

Plastic tube - 5/16 inch (tube)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Deli drawer (tray)

This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Door shelf bin (door basket)

Sold individually.

Ice maker assembly - 6 wire (icemaker assembly)

NOTE: As per manufacture the secondary (smaller) wire connector has 6 wires in it. If original ice maker has 3 wire connector see part number PS7788172. Please verify connector before ordering.

Water inlet valve assembly (valve asy,wa)

This includes the primary and secondary valves along with the wire harness.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Refrigerator light board assembly (led assembly)

This light board is located behind the light lens and has LED lights that illuminate the interior of the refrigerator compartment when the door is opened.

Left side connector rail (connctr,rail)

Evaporator fan motor (motor,dc)

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Spring,lever (spring lever)

Refrigerator water reservoir (tank assembly)

The water reservoir holds the water for the water dispenser as the water chills.

Gasket,door (gasket assembly)

Freezer door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the freezer compartment.

Bucket assembly,ice (bucket asy,b)