79572059116 Kenmore Refrigerator Parts List

Handle screw (refrigerator door handle mounting bolt)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Door basket assembly (refrigerator door bin)

Refrigerator door bin AAP73252202 is an original equipment manufacturer (OEM) part that fits some Kenmore Elite bottom-freezer refrigerators in the following series: 7957204, 7957205, 7957209, 7957218, 7957248, 7957311, 7957315, 7957401, 7957402, 7957404, 7957409, 7957504, 7957998 and 7957999. Also fits some LG bottom-freezer refrigerators in series LFX25991, LFX31925, LFX31935, LFX33975 and LMX31985. This door bin has an irregular shape?it's 13-1/2 inches wide, 9-1/2 inches deep on the left, 10-1/8 inches deep on the right and 4-1/4 inches tall. To install door bin AAP73252202, slide it into the door just above desired location and push down on the bin until it snaps into place.

Plastic tube - 5/16 inch (refrigerator water tubing)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Basket assembly,door (refrigerator door bin)

Door holder (refrigerator door closer)

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Push button switch (refrigerator door light switch)

This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.

Left side connector rail (refrigerator freezer basket support rail, left)

Spring,lever (refrigerator dispenser ice chute door hinge spring)

Ice maker assembly - 3 wire (refrigerator ice maker assembly)

NOTE: The Secondary (smaller) wire connector has 3 wires in it. If original ice maker has 6 wire connector see part number AEQ73110205. Please verify connector before ordering.

Refrigerator water reservoir

The water reservoir holds the water for the water dispenser as the water chills.

Evaporator fan motor (refrigerator evaporator fan motor)

Elbow (refrigerator water tube fitting)

Water inlet valve (refrigerator water inlet valve)

Switch,micro (refrigerator dispenser switch)

Motor assembly,dc (refrigerator evaporator fan motor assembly)

Evaporator fan motor circulates air through the fresh food compartment for efficient cooling.