79572063110 Kenmore Refrigerator Parts List

Handle screw (refrigerator door handle mounting bolt)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Plastic tube - 5/16 inch (refrigerator water tubing)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Refrigerator spring

This is a replacement door mullion spring for your refrigerator. The door mullion is the flap that allows the doors on your French-door style refrigerator to close. The spring allows the mullion to fit into a latch on the refrigerator door frame, and lets the door stay closed properly. If you have a damaged spring, your door will not close properly. This part is sold individually.

Basket assembly,door (refrigerator door bin)

Filter assembly,air cleaner (refrigerator air filter)

Refrigerator Air Filters are a key component for neutralizing odors and ensuring a fresh stream of air into your refrigerator. Swapping your old filter out for a fresh one isn’t difficult and should take less than five minutes. This OEM filter measures approximately 3 inches (length) x 3 inches (height) x 5 inches (Depth). Air filters should be changed every 6 months depending on usage.

Ice maker assembly - 6 wire (refrigerator ice maker)

NOTE: As per manufacture the secondary (smaller) wire connector has 6 wires in it. If original ice maker has 3 wire connector see part number PS7788172. Please verify connector before ordering.

Door holder (refrigerator door closer)

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Left side connector rail (refrigerator freezer basket support rail, left)

Spring,lever (refrigerator dispenser ice chute door hinge spring)

Refrigerator water reservoir

The water reservoir holds the water for the water dispenser as the water chills.

Gasket,door (refrigerator freezer door gasket)

Freezer door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the freezer compartment.

Evaporator fan motor (refrigerator evaporator fan motor)

Gasket assembly,door (refrigerator door gasket, right)

Elbow (refrigerator water tube fitting)

Water inlet valve (refrigerator water inlet valve)