79573139410 Kenmore Refrigerator Parts List

Water inlet valve assembly (refrigerator water inlet valve)

This includes the primary and secondary valves along with the wire harness.

Door holder (refrigerator door closer)

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Evaporator fan motor (refrigerator evaporator fan motor)

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Spring,lever (refrigerator dispenser ice chute door hinge spring)

Screw,set (refrigerator door handle mounting screw)

Crisper shelf glass (refrigerator glass shelf)

Refrigerator door bin

This door bin is for refrigerators. Door bin attaches to the inside of the refrigerator door and mostly holds jars and bottles.

Leg assembly,adjust (refrigerator leveling leg)

Front plate assembly (refrigerator flipper assembly)

Drier assembly (refrigerator filter dryer)

Defrost sensor assembly (refrigerator defrost sensor assembly)

Refrigerator compressor overload protector

The compressor overload protector attaches to the compressor and shuts off the compressor if the compressor motor draws too much current.

Hinge assembly,center (refrigerator door hinge, center)

Basket assembly,door (refrigerator door bin)

Holder,bracket (refrigerator water tubing clip)