91195875891 Kenmore Range Parts List

Single heating element support clip (broil element support)

The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.

Oven sensor (sensor)

The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.

Hinge with roller - left side (oven door hinge left)

This hinge is located on each side of the oven door

Hinge with roller - right side (oven door hinge right)

This hinge is located on each side of the oven door.

Large haliant burner with limiter - 8" (surface element 2000w)

This haliant burner element is a gneuine OEM replacement part for your stove. This element is 8 inches in diameter. The element lies underneath the stovetop, and will need to be replaced if it stops heating. To complete this repair you will need a 1/4 inch nut driver and a flat blade screwdriver. To access the element, open the oven door and unscrew the two screws under the lip of the cooktop.

Screw (screw 10-16 x 7/16")

Sold Individually.

Haliant burner with limiter - 6" - 1500w (surface element 1500w)

Screw (screw 10-32 x 17/32")

Sold Individually.

Ignitor mounting screw (screw 10-32 x 1/4")

Sold Individually.

Oven light housing (oven lamp holder)

Must buy bulb locally as per manufacturer.

Broiler pan - large (broiler pan)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below making clean up easier. This part is gray in color, made of enameled porcelain for an easy-to-clean, durable and made to last. The pan measures approximately 17” wide by 13” deep, insert measures 15 1/2” wide by 13” deep. This is a genuine OEM part.

Rear drawer glide (rear slide block-lt/rt)

Also called Rear Block.

Screw (screw 10-16 x 13/16")

This screw is black in color and sold individually.

Bake element - 3410w (bake element)

Light lens (indicator light lens)