1992 Parts List

Ice bucket auger drive motor kit (motor assy., auger (w/yo - series 10)

This motor kit comes with a thermally protected motor, a washer and a mounting bracket. The motor performs eighteen revolutions per minute, carries 115 volts, and drives the auger for the icemaker.

Screw

This screw is sold individually.

Food door gasket (measures 30-3/4" by 39') (refrigerator door gasket (white))

This white fresh food door gasket measures approximately 30-3/4 inches by 39 inches. It is used on many fresh food doors of top mount model refrigerators that have been manufactured since 1980.

Plastic tubing (refrigerator water tubing)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Ice maker front cover (refrigerator ice maker module cover)

Bolt assembly

Screw (refrigerator screw)

Sold individually.

Refrigerator compressor start relay

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.

Leveler

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Defrost heater (refrigerator defrost heater)

This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.

Defrost evaporator pan (drain)

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.

Speed nut (mtg clip)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Defrost thermostat - with wire and clip (refrigerator defrost bi-metal thermostat)

This refrigerator defrost thermostat will cut out at 80 degrees Fahrenheit and kick back when the temperature drops to 15 degrees Fahrenheit.

Water hose clamp (clip)

These tube clamps are sold individually. The screw is not included.

Supporter,leg (leg support for the left side.)