25370754407 Kenmore Refrigerator Parts List

Evaporator fan blade (refrigerator evaporator fan blade)

If your refrigerator or freezer is too warm or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.

Screw

Cross Recessed Pan Head Screw Size: 10-16 X 0.500

Refrigerator condenser fan motor kit (shroud condenser)

This is a replacement condenser fan motor kit for your refrigerator. This six-piece kit contains foam tape, 2 screws, the fan blade, the new motor mounting bracket, and the condenser fan motor. The condenser fan motor is found in the back of the refrigerator, and it moves air across the compressor and the condenser to keep them cool. If the motor has failed, the condenser and the compressor will run hot, and this can cause the refrigerator not to cool. This is an OEM part from the manufacturer.

Fan blade

This part blows air over the condenser.

Cold control thermostat (temperature control)

This cold control thermostat cycles on and off regularly to keep your refrigerator cold.

Hexagonal screw (hinge screw)

Sold individually.

Door rack freezer (end cap)

This part is the replacement door rack for your refrigerator freezer. It is made of white plastic and is approximately 23 inches by 5 inches in size. The door rack connects to your freezer door and allows you to store items on the door shelf, without the items falling out when you open or close the door. The main reason to replace the door rack would be if it is cracked, broken, or missing. To replace the door rack, carefully pop it out of the guide holes in the freezer door and snap the new rack into place. This part is sold individually and is a genuine OEM part.

Drive gear (gear)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Ice container (container)

Freezer door gasket (freezer gasket)

This door gasket is used to seal the freezer door when closed.

Wire shelf (ff wire shlf)

Sold individually.

Center hinge pin (pin-center h)

Crisper pan cover (crisper cover)

Screw

Sold individually.

Water tube