4KMVWC130EQ0 Washer Parts List

Washing machine suspension rod kit (washer suspension rod kit)

Screw, 8/18 x 3/8 (washer screw)

This screw is sold individually.

Touch-up paint - white (appliance touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Lid bumper (washer lid bumper)

This single gray and white washer lid bumper contains a rubber bottom to help cushion the lid as it closes against the cabinet lid. If your bumper is missing you should replace the part to avoid metal on metal causing damage to the top of the washer. This is a genuine OEM part and is sold individually.

Washer drive pulley

This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the splines on the clutch assembly are stripped and the washer is making noise, or if you are having problems with the wash and spin cycles. You will need to access the bottom of the washer for this repair. It is easiest to if you disconnect your washer from both the water and power source, and lay it on its back. The clutch assembly contains 6 parts, and all are included with the kit. It is also important to change out the entire assembly, rather than individual pieces.

Drive belt (washer drive belt)

The main drive belt is designed to ride on the pulley until the basket gets up to speed.

Lid hinge mounting screw (washer screw)

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

D-shaped knob insert (laundry appliance control knob clip)

This insert is sold individually. Knob not included. Knob is sold separately.

Lid hinge bearing (washer lid hinge bearing)

This is the bearing for the lid hinge. Sold individually.

Washer (washing machine washer)

This part goes on the agitator retaining bolt.

Lid latch strike (washer door strike)

This part is the replacement lid latch or latch assembly for your top-load washer. The lid latch holds your washer door closed, and allows the washer to run its cycle. If the lid latch is damaged, your washer door may not close properly and you may not be able to run your washer. The latch is found under the lid and can be screwed out and replaced. You will need a Phillips-head screwdriver for this repair. This part is sold individually and is and OEM part from the manufacturer.

Spray paint - 12 oz. - white (appliance spray paint (white))

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Hose clamp (washer hose clamp)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Dryer screw (screw, 10-16 x 3/4)

11-16 x 3/4 Sold individually.

Inlet hose - 5 ft (washer fill hose)

This hose can handle hot or cold water and is five feet long.