68-456747 Parts List

Oven bake element (oven bake heating element with push-on wire terminals)

The bake element is located on the bottom of the oven cavity to supply heat for baking. The element terminals are male spade connectors and have push-on wire terminals. This element measures 19 ¼ inches wide by 15 1/2 inches deep and extends approximately 3 inches past the bracket to the element terminals. If your oven is not heating evenly, the element will not heat or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.

Long oven sensor (oven temperature sensor kit, 6 inches long. The sensor includes two wire harness adapters for a variety of applications and installation instructions.)

The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Range infinite burner switch - 8 inch (surface burner control switch for 8-inch burner. The surface element switch sends voltage to the surface element coil. If the switch is defective, the)

This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.

Door gasket

The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.

6 inch element with limiter (6" smoothtop range element with overheat limit switch)

This element can be used for the left front or right rear.

Infinite switch - 6 inch (surface burner control switch for surface element)

Clock knob - black (clock/temperature knob, black)

The clock knob allows you to adjust the clock located in the control panel section of your range. This clock knob is less than an inch long, black in color, made of plastic and is sold individually. This genuine OEM knob will accept a D shaped shaft.

Elmnt-surf (8" smoothtop range element with overheat limit swit)

Door hinge kit (door hinge kit with screws. The hinge on your oven door can be different based on your serial number. Please call us with your model and serial number)

This oven door hinge assembly comes with two screws and is intended for use with many ovens. It can be used on either the left or right hand side.

Broil element (16 inch long x 13.5 inch wide) (element,broil)

This oven broil element can be used with some of Maytag's brands of electric ovens.

Electronic range control (electronic clock control kit, black)

This part is only available in Black. The white has been discontinued.

Knob black (knob (blk))

Sold individually.

Discontinued (latch kit)

Discontinued

Board- ter (board, terminal)