71039 LG Refrigerator Parts List

Water inlet valve assembly (primary and secondary water inlet valve assembly with wire harness)

This includes the primary and secondary valves along with the wire harness.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Evaporator fan motor

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Spring,lever (refrigerator dispenser ice chute door hinge spring)

Refrigerator water reservoir (water tank)

The water reservoir holds the water for the water dispenser as the water chills.

Elbow (refrigerator water tube fitting)

Ice maker assembly kit (refrigerator ice maker assembly. Before replacing the ice maker, ensure that the freezer is operating at the proper temperature.)

Screw,set (screw)

Compressor (set assembly compressor)

This part must be installed by a licensed and trained LG technician that is able to perform a software update, which is required for the installation of this compressor. Part number CJT30000002 is needed to perform the update. Also, the three pins on the side of the new compressor may be oriented differently than the original. If different, when installing the new compressor the compressor electrical connector must be rotated 45 degrees counter-clockwise.

Crisper shelf glass (glass shelf)

Cap assembly,head (water filter bypass cap)

Refrigerator door bin (LG appliance door basket)

This door bin is for refrigerators. Door bin attaches to the inside of the refrigerator door and mostly holds jars and bottles.

Temperature sensor (defrost sensor)

This part monitors the temperature and makes sure the compressor cycles on and off.

Front plate assembly (LG front mullion plate assembly)

Defrost sensor assembly (temperature sensing thermistor)