7MMVWC200DW0 Washer Parts List

Lid latch assembly (washer lid lock assembly)

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

Washing machine suspension rod kit (washer suspension rod kit)

Thrust spacer (washer agitator thrust washer)

This white thrust spacer is made of plastic and is also commonly referred to as a retainer ring. It is approximately 2 1/2-inch in diameter. The thrust spacer is used in the agitator assembly between the agitator and the auger. The thrust spacer supports the agitator auger as it moves. It is used in many direct drive washer machine models. If your washer will not agitate or is noisy, you may need to replace the thrust spacer. Please be sure to disconnect the power to your washer before starting your repair. You may need agitator grease for the repair. This is a genuine OEM part.

Seal, inner cap (washer o-ring)

Also known as an O-Ring. This black o-ring seal is three inches in diameter.

Screw, 8/18 x 3/8 (washer screw)

This screw is sold individually.

Touch-up paint - white (appliance touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Lid bumper (washer lid bumper)

This single gray and white washer lid bumper contains a rubber bottom to help cushion the lid as it closes against the cabinet lid. If your bumper is missing you should replace the part to avoid metal on metal causing damage to the top of the washer. This is a genuine OEM part and is sold individually.

Agitator cap barrier with seal (washer agitator cap)

The O-Ring is included with this cap. It can be purchased separately as Part #WPW10072840.

Washer drive pulley (washer drive pulley and splutch assembly)

This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the splines on the clutch assembly are stripped and the washer is making noise, or if you are having problems with the wash and spin cycles. You will need to access the bottom of the washer for this repair. It is easiest to if you disconnect your washer from both the water and power source, and lay it on its back. The clutch assembly contains 6 parts, and all are included with the kit. It is also important to change out the entire assembly, rather than individual pieces.

Drive belt (washer drive belt)

The main drive belt is designed to ride on the pulley until the basket gets up to speed.

Shift actuator - 120v 60hz (washer actuator)

This part changes the transmission from agitation to spin mode. This actuator is for washers. Actuator shifts the splutch and monitors the position of the splutch.

Lid hinge mounting screw (washer screw)

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

D-shaped knob insert (laundry appliance control knob clip)

This insert is sold individually. Knob not included. Knob is sold separately.

Lid hinge bearing (washer lid hinge bearing)

This is the bearing for the lid hinge. Sold individually.

Washer (washing machine washer)

This part goes on the agitator retaining bolt.