861-4730-090 Parts List

Rear drum bearing kit (drum rear bearing and post kit, with hardware)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Drive belt (dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time.)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Lint filter with frame (dryer lint filter. This filter should be cleaned before every load to ensure proper airflow. If the lint filter is torn or damaged, replace it.)

The lint filter and frame for your dryer traps unwanted lint and debris so your dryer can effectively dry your clothes. If the old lint filter is cracked or clogged, or the dryer takes too long to dry or if excessive lint is accumulating inside the dryer or its venting, you may need to replace the lint filter. To replace the filter, simply remove the old, damaged filter, and replace it with the new one. This part is approximately 13 inches by 3 inches.

Door latch (dryer door catch kit)

This part helps to keep the door closed while the machine is running.

Rear drum bearing (rear dryer drum bearing. Be sure to enter your model number to ensure that you have the right bearing for your model.)

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

Front drum slide kit (front drum supports/glides (2), with hardware)

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

Idler pulley wheel (idler pulley wheel with spacer and retainer clip)

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Heater 2-coil restring kit - 240v (heating element kit, includes two coils and hardware, 240 volts)

This restring coil kit is used to replace the existing coil in a dryer's heating element.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Door switch (dryer door switch, 3-wire. Use the two smaller terminals for models with only two wires to the switch (no drum light).)

This part has three terminals. Note: Use the two smaller terminals for models that only have two wires to the switch.

Motor pulley with screws (motor pulley with set screw)

Terminal block - 220 volts (terminal block for power cord, comes with no hardware)

Blower wheel

Felt seal as (felt seal, front panel to blower housing)

Strike (door strike)