90290LB GE Refrigerator Parts List

Defrost thermostat kit (defrost thermostat kit, 55 degrees)

This refrigerator defrost thermostat will cut out at 55 degrees F and kick back in when the temperature drops to 35 degrees F. It comes with connectors and the mounting brackets.

Compressor start relay (compressor relay)

This part is the replacement compressor start relay for your refrigerator. It is made of black plastic and is approximately 1 ¼ inches long and 1 inch wide. The compressor start relay attaches to the compressor and helps to start the compressor motor. If the compressor will not start, or if your refrigerator or freezer is too warm, you may need to replace the compressor start relay. This part is sold individually. It is an OEM part sourced directly from the manufacturer.

Freezer shelf support (shelf support clip)

Sold Individually.

Evaporator fan blade kit (fan blade, plastic)

Ice bucket (ice dispenser bucket)

Defrost timer (defrost timer. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.

Fill tube grommet (icemaker fill tube grommet)

This fill tube grommet is used on the icemaker.

Scr 8-18 tpt 1/4 (screw)

Evaporator fan motor kit (evaporator fan motor assembly)

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.

Screw (screw, pack of 12)

Comes 12 in a pack.

Freezer wire shelf (freezer shelf)

Door shim cam (shim)

Sold individually.

Shoulder screw (scr 8-18 ab ihxw 9/16 s)

This shoulder screw is sold individually.

Upper crisper drawer (upper pan)

Plastic tubing (1/4" plastic tubing, 8 1/2 feet long)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.