ACO1560AS Parts List

Fuse,time delay

This line fuse protects the microwave by shutting down if there is an electrical surge. If your microwave is not turning on, you may need to replace the fuse. This part is just over an inch long, metallic on both ends and white ceramic in the middle. Please remember to disconnect power to your microwave before starting your repair. This is a genuine OEM part.

Holder,cook auxiliary

Filter (filter, charcoal)

Sold individually.

Screw,tapping

Wave guide rivet (rivet, plastic)

This rivet is used for the stirrer cover/wave guide. They are sold individually.

Turntable assembly

This turntable assembly, also known as a rotating ring, is a genuine OEM replacement part for your microwave. It is brown in color and about 10 inches in diameter. This part supports the glass turntable and keeps it in place. Replacing this part is very easy and requires no tools. Simply remove the glass tray, pop out the existing ring and replace with the new one.

Black sleeve diode (diode)

The black sleeve microwave diode is used as an electrical current control device inside the appliance. It will allow power to go one way but not the other. If your microwave is not heating properly you may need to replace this part. Please remember to disconnect power to the microwave before starting the repair. This is a genuine OEM part.

Door interlock switch kit (switch, micro)

The door interlock switch kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16-inch terminals. The switches are used to sense when the microwave door is open or closed. If your microwave will not start, or will not turn on, you may need to replace these switches. This is a genuine OEM kit. Please remember to disconnect the power to your microwave before starting the repair. PLEASE NOTE: The door interlock switch kit includes 2 single pole, double throw (SPDT) micro switches. As per the manufacture for the secondary interlock switch order part # 56001100.

Turntable motor coupler

The turntable motor coupler connects the turntable motor to the tray. If the turntable on your microwave will not rotate, you may have a faulty motor coupler. The coupler commonly has a D shaped opening that fits tightly onto the motor shaft. If it is cracked, or worn it will need to be replaced. This is a genuine OEM replacement part sourced directly from the manufacturer.

Plate,mount (plate,bottom)

Rivet

Magnetron

Motor, ac synchronous

If the turntable on your microwave does not rotate, or you can hear a grinding noise, the problem may be with the motor. The motor is typically located below the floor of the oven, and is accessed through the bottom. The motor is normally held in place with a retaining screw and will have two wires attached to it as well. If the motor is making a grinding noise it will need to be replaced. If the motor does not turn, you can check for voltage or continuity with a multi-meter. Make sure the power is disconnected from your microwave before beginning this repair.

Adapter - exhaust (adapter, exhaust)

Air damper (damper, air)