ART2527AC-PART2527AC0 Parts List

Tray (ice cube making tray)

This fourteen cube ice cube tray is eleven inches long. It is all white in color and is made entirely of plastic.

Relay and overload combination (compressor start device combinaton relay and overload)

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Kick plate retaining clip

This kick plate retaining clip is sold individually and is made entirely of metal. If you are needing the kick plate as well, remember to check with your model number as these clips may already be included.

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw, 8-18 x 5/8 hex-head slotted)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw kit

Includes 2 screws.

Screw (screw- sm)

This screw is sold individually

Plastic tubing (1/4" plastic tubing, 8 1/2 feet long)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Ice maker wire harness (wire harness, icemaker)

This part connects to the electrical and allows power to flow through your appliance.

Ice maker front cover (ice maker module front cover)

Bottom hinge pin (pin, bottom hinge)

Sold individually.

Drawer roller wheel

This drawer roller wheel is all white in color and is made entirely of plastic. This wheel is used with the drawers of some refrigerators.

Refrigerator door gasket (refrigerator door gasket {34 1/2"-42"})

This refrigerator door gasket is forty-two inches long. It is all white in color and is made entirely of rubber. At thirty-four and a half inches wide, this gasket is intended for use with top mount refrigerators.

Door stop (stop, door (blk))

This part is located in the bottom hinge section.