CED7464GW0 Dryer Parts List

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Hinge (washer door hinge)

Motor pulley - 60 hz. (dryer motor pulley)

Sold individually.

Spray paint - 12 oz. - white

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Drum support roller shaft - right hand threads (dryer support roller shaft)

This shaft is for the front with right hand thread. Sold individually.

Cap (laundry appliance hinge pin cap)

High limit thermostat (dryer high-limit thermostat)

This authentic OEM high limit thermostat is made for your dryer. It is an important dyer element, because it will automatically shut off the heating element when it overheats. Be sure to disconnect the power to your dryer before you begin this repair.

Lint screen door cover (dryer lint screen housing door)

Lint filter

NOTE: As per manufacture the felt seal is no longer needed with the lint filter.

Drying rack

This dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits dryers that are 29 inches wide, have the letter "E" following the numbers in the model number, and whose dimples are four and a half inches apart in the back of the dryer drum.

Thermal cut-off with high limit thermostat (dryer thermal cut-off kit)

The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Washer (dryer washer)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (dryer terminal block)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal

This part seals between the blower housing and the blower housing cover.

Spring