CTF14CBC Hotpoint Refrigerator Parts List

Light switch (switch light)

The refrigerator light switch turns the interior light off and on when you open or close the refrigerator door. The light switch also prevents the front dispenser from working if the refrigerator door is opened. If the switch has shorted out or the light bulb is not turning on when the door is open, you may need to replace the switch. This switch is white in color and measures approximately 1 1/2” L x 1 1/4” W. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting the repair.

Defrost timer - 120v 60hz (control defrost)

The defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. This 120V 60Hz defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange. If your refrigerator is too warm, freezer section is too warm, freezer is not defrosting, or leaking, you may need to replace the defrost timer. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Package of 12 screws (scr 8-18 ab rndw 5/8 ss)

This is a package of twelve Phillips-head screws. They can be used as replacement screws in refrigerators, ice makers, or freezers. Be sure to check that your appliance model is compatible with these screws. The screws are approximately ¾ of an inch in length.

Ice cube tray (tray ice)

14 Cube.

Evaporator fan blade kit (ring compression)

Evaporator fan motor kit (motor evap fan)

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.

Screw (scr 12-24 hxw 1 1/64 spp)

Comes 12 in a pack.

Door shelf retainer bar end cap (cap shelf frt)

This is the replacement door shelf retainer bar end cap for your refrigerator. An end cap connects to the lower shelf bar on either side, and then snaps into position on the refrigerator door, allowing you to store items in the refrigerator door. To replace the end cap, simply disengage the whole bar assembly from the refrigerator door, then disengage the hook on the end cap from the rest of the bar assembly. Then, simply snap the end cap back into place, and connect it back to the refrigerator door. This part is sold individually.

Retainer bar end cap (cap shelf frt)

Power cord (cord power)

Water tubing clip (clamp cable)

Door hinge pivot (thimble seal asm)

Fresh food door gasket (gasket, ff door)

This white fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Twist-in shelf support studs (support shelf)

These support studs are sold in a pair.

Twist-in shelf support stud (support shelf frontr)

This stud is sold individually.