CWE19SP2NKS1 GE Refrigerator Parts List

Temperature sensor (sensor temp ff)

The temperature sensor, also known as a thermistor, helps detect the temperature inside the refrigerator and sends the information to the control board. If your refrigerator is too warm or not cooling properly, you may need to replace the temperature sensor. This is a genuine OEM part. Please make sure to disconnect the power to the refrigerator before starting your repair.

Compression ring (ring compression)

The compression ring works for a variety of fans throughout your refrigerator, the evaporator fan or condenser fan. If you notice your refrigerator or freezer is too warm, or there is an unusual sound during operation you may need to replace the compression ring. This part is made of metal, measures approximately 0.25” L x 0.5” in diameter, and is sold individually. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Run capacitor (capacitor 12 uf)

The run capacitor is attached to the compressor and is 12 UF. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Door handle fastener (fastener door handle)

This is a door handle fastener to secure the handle to your refrigerator drawer. It is also known and a mounting bolt or screw. It is approximately 1 inch in total length, and is made of metal.

Evaporator fan blade (blade evap fan asm)

This evaporator fan blade is for your refrigerator, and it circulates air so that the temperature of the fridge is regulated. This model has 3 blades, and is a little more than 4 inches in diameter. It is made of white plastic and is sold individually. If your refrigerator is noisy and you hear a clicking sound, it is a good indication that the evaporator fan blade is warped or damaged. If the fridge or freezer sections become too warm, the fan could be to blame as well.

Shelf support (support shelf)

This plastic shelf support, or shelf stud connects the shelf to your refrigerator. To replace the shelf support first remove the shelves and drawers from your refrigerator, then remove the damaged or faulty stud before installing the new one. This genuine OEM shelf support has an outside diameter of approximately half an inch.

Shelf door module rh

This door bin is for refrigerators. The door bin attaches to the inside of the refrigerator door and typically holds jars and bottles. Follow the instructions in the owner's manual for installing this part. (right hand)

Screw (screw 10-32 gxtt flp 595)

Size: 10-32 GXTT FLP .595 Sold individually.

Screw - 8-18 ab ihw 5/8 s (screw 8-18 ab ihw 5/8 s)

Sold individually.

Hinge cover screw (screw hinge cover)

Sold individually.

Blade conf fan assembly (blade conf fan asm)

Fan motor grommet (grommet fan motor)

Can be used with the evaporator or condenser fan motor.

Defrost thermostat (thermostat def)

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

Scr 8-18 ca hx 1/2 s (scr 8-18 ab hxw 1/2 s)

Refrigerator temperature sensor cover (grille sensor)