DBXR453GT2WW Dryer Parts List

Timer knob (knob, timer wh)

This is a timer knob for your dryer. It is found on the control panel and allows you to turn your dryer on and adjust the settings. If the timer will not advance, or you notice the knob is damaged, you will need to replace it. This timer knob is white in color with a small red arrow printed on it, and is made of plastic. It is sold individually and is a genuine OEM part from the manufacturer.

Interlock switch (switch interlock)

This switch is multi purpose, for a dishwasher the switch is a simple on/off mechanism that prohibits the appliance from operating when the door is open. For a dryer, this switch will let the dryer know if the belt breaks and shut power off to the dryer. If your dryer will not operate or your dishwasher will not start you may need to replace the switch. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Foam seal (gasket)

This is 39 inches long.

Door latch

This part helps to keep the door closed while the machine is running.

Door switch (switch door)

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

M-series primary dual coil gas valve (coil dual)

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

Igniter (igniter asm)

NOTE: Be very careful to not handle the igniter by its gray part as it's very fragile. Hold it by its white tip only.

Cycling thermostat - 4 wire (thermostat)

This thermostat helps to regulate the dryer's internal temperature. L210-30F

Adjustable leveling screw (levelling screw)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

M - series secondary coil - 2 terminals

This part is the replacement main valve coil for your dryer. It is black and white in color and has 2 terminals. It is approximately 1 inch long and 1 inch wide. The main valve coil opens the gas valves while the dryer is running. This coil is used with two coil gas shut off valve assemblies. Be sure to turn off the gas before you begin this repair. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Door strike

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the door will not lock properly and not only will this cause the door to swing open, but it won’t allow the dryer to start properly. It is a small piece of metal, about 1 inch in length and is sold individually.

Nut (bracket motor)

Natural gas to liquid propane conversion kit

This conversion kit changes the dryer from natural gas to liquid propane. Installation instructions are included.

Drive motor (motor & pulley asm)

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Blower wheel

This wheel attaches to the motor.