DCCH43EHW GE Dryer Parts List

Drum belt (dryer drum belt)

Used to turn the drum.

Rear bearing (rear bearing cup)

Bearing Only. This part helps your appliance run as quietly as possible.

Drum glide (glide-drum)

Sold individually. There are some dryers that require 2 per dryer. They attach to the outer-most sides of the bearing.

Rear bearing kit

This kit comes with the rear bearing, shaft support, lubricant and other items required for the installation.

Upper felt seal with adhesive

Handle (handle-door white)

Screws are not included. Handle only.

Rear bearing shaft support (rear dryer drum bearing assembly)

Lower felt seal with adhesive

Heating element with housing (heating element and housing assembly)

Thermal limiter (dryer thermal fuse)

This part is found in the same location as the Terminal Block at the back of the Dryer. It acts as a safety device which prevents your appliance from overheating.

Control thermostat (thermostat, l140-10f)

This thermostat controls the internal drying temperature. Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 140 degrees Fahrenheit and a differential of 10 degrees. Meaning that with this thermostat, the heating element will cut out at 140 degrees and cycle back on once the internal temperature drops by 10 degrees.

Screw-lock 10-16x 50 (lock screw)

Dryer bearing bracket (bearing bracket)

This bracket is used on the drum bearing.

High limit safety thermostat (safety thermostat, l260-70f)

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. The element will kick back in when the temperature drops to 190 degrees Fahrenheit - the differential of 70 degrees.

Screw 8-18 x .31 (screw)

This screw is sold individually. Size 8 - 18 x 0.31