DDC4408AAL GE Dryer Parts List

Rear drum bearing kit (rear drum bearing kit. *bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum beari)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Drive belt (dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time.)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Door latch (dryer door catch kit)

This part helps to keep the door closed while the machine is running.

Rear drum bearing (rear dryer drum bearing. Be sure to enter your model number to ensure that you have the right bearing for your model.)

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

Front drum slide kit (front drum supports/glides (2), with hardware)

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

Idler pulley wheel (idler pulley wheel with spacer and retainer clip)

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Adjustable leveling screw (leveling leg, adjustable)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Screw

This screw is sold individually.

Heater 2-coil restring kit - 240v (heating element kit, includes two coils and hardware, 240 volts)

This restring coil kit is used to replace the existing coil in a dryer's heating element.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Blower wheel (blower wheel for dryer)

This wheel attaches to the motor.

High limit thermostat (high limit thermostat, l258-50f)

With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)

Clamp& screw (clamp & screw kit for blower wheel)

Lint filter

Hinge bushng (hinge bushing)