Parts for Kenmore Models DDC4500SBM

Drum bearing slide - white (sold individually) (slide drum (wh))

This single white drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum will not tumble, you many need to replace the slides. The manufacturer recommends replacing both slides at the same time; there are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect power to the dryer before starting your repair.

Easy Part #:: EAP755842

Availability:: In Stock

Price:: $17.29

Drum bearing slide Green (sold individually)

This single green drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum won?t tumble you many need to replace the slides. The manufacturer recommends replacing both slides at the same time. There are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect the power to the dryer before starting your repair.

Easy Part #:: EAP6447706

Availability:: In Stock

Price:: $13.30

M series new style coil kit

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:: EAP334310

Availability:: In Stock

Price:: $26.40

Rear drum bearing kit (washer)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Easy Part #:: EAP267529

Availability:: In Stock

Price:: $62.96

Drive belt (belt drive)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Easy Part #:: EAP2350043

Availability:: In Stock

Price:: $25.19

Idler pulley wheel (pulley idler)

The idler pulley helps maintain the proper amount of tension on the drive belt to turn the drum. The idler pulley is located between the motor pulley and drum to provide tension on the belt. If the part has become worn, it could cause the dryer to be noisy or squeaky, and the pulley will need to be replaced. This part is yellow in color, made of plastic, and measures approximately 2 1/2” in diameter. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Easy Part #:: EAP265721

Availability:: In Stock

Price:: $28.58

Interlock switch (switch interlock)

This switch is multi purpose, for a dishwasher the switch is a simple on/off mechanism that prohibits the appliance from operating when the door is open. For a dryer, this switch will let the dryer know if the belt breaks and shut power off to the dryer. If your dryer will not operate or your dishwasher will not start you may need to replace the switch. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Easy Part #:: EAP1481922

Availability:: In Stock

Price:: $24.28

Foam seal (gasket)

This is 39 inches long.

Easy Part #:: EAP2577674

Availability:: In Stock

Price:: $12.00

Door latch

This part helps to keep the door closed while the machine is running.

Easy Part #:: EAP3502777

Availability:: In Stock

Price:: $14.53

Door switch (switch door)

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Easy Part #:: EAP2344321

Availability:: In Stock

Price:: $23.67

M-series primary dual coil gas valve (coil dual)

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

Easy Part #:: EAP268153

Availability:: In Stock

Price:: $31.37

Igniter

NOTE: Be very careful to not handle the igniter by its gray part as it's very fragile. Hold it by its white tip only.

Easy Part #:: EAP12342916

Availability:: In Stock

Price:: $46.97

Adjustable leveling screw (screw levelling)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Easy Part #:: EAP1021358

Availability:: In Stock

Price:: $13.36

M - series secondary coil - 2 terminals

This part is the replacement main valve coil for your dryer. It is black and white in color and has 2 terminals. It is approximately 1 inch long and 1 inch wide. The main valve coil opens the gas valves while the dryer is running. This coil is used with two coil gas shut off valve assemblies. Be sure to turn off the gas before you begin this repair. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Easy Part #:: EAP268154

Availability:: In Stock

Price:: $27.52

Door strike

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the door will not lock properly and not only will this cause the door to swing open, but it won’t allow the dryer to start properly. It is a small piece of metal, about 1 inch in length and is sold individually.