DDE9205NC GE Dryer Parts List

Rear drum bearing kit (rear drum bearing kit. *bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum beari)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Adjustable leveling screw (leveling leg, adjustable)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

High limit thermostat (high limit thermostat, l258-50f)

With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)

Door switch (dryer door switch, 3-wire. Use the two smaller terminals for models with only two wires to the switch (no drum light).)

This part has three terminals. Note: Use the two smaller terminals for models that only have two wires to the switch.

Timer knob (timer knob, chrome and black, 1ea.)

This knob accepts a D-shaped shaft.

Multi rib belt - 4 ridges (dryer belt, length 99 1/8”, width 3/8”, characteristics, 4 ridges, flat)

This dryer drum belt goes around the dryer drum and the pulleys to rotate the drum once motor is activate.

Heater coil restring kit - carries 250 volts (heating element kit, for 250 volt export models)

This heating element coil restring kit is intended for use with many of GE's brands of electric clothes dryers. It carries 250 volts, and includes two coils.

Terminal block - 220 volts (terminal block for power cord, comes with no hardware)

Blower wheel

Slide assembly (drum slide assembly, heavy-duty)

Thermostat (limit: 140-15) (thermostat l140-15f)

Use this cycling thermostat with your GE brand clothes dryer. It has a limit of 140 degrees Fahrenheit and a differential of 15 degrees. This means that with this thermostat, your dryer's heating element will cut out at 140 degrees Fahrenheit and cycle back on when the dryer's internal temperature drops by 15 degrees.

Sw button (push button)

Discontinued (dryer door handle)

Lint filter