DDW361RAW-PDDW361RAW0 Parts List

Lower wheel assembly (wheel assembly for lower dishwasher dishrack. The dishrack wheels enable the dishrack to move in and out of the dishwasher.)

The rack wheel and axle attach to the lower rack to allow you to slide the rack in and out easily. If your dish rack is not moving in and out of the dishwasher properly, you may have a broken or missing wheel and it will need to be replaced. The wheel and axle are white in color, made of plastic, and sold individually. This is a genuine OEM part kit.

Door gasket (dishwasher door gasket. This gasket creates a seal around the dishwasher to prevent water from leaking out. If the door seal is torn, the dishwasher w)

The dishwasher door gasket provides a water tight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking you may need to replace the door gasket. The door gasket can be installed by simply pressing it into the channel around the door. This black door gasket measures 66.5-inch L x 42.7-inch W x .445-inch, is made of rubber and is a genuine OEM part.

Adjustable peg clip (dishrack tine clip for adjustable tines.)

This dishrack clip is intended for use with dishwasher dishracks that have adjustable pegs. This clip is only about four inches long.

White dishrack roller (upper rack wheel assembly)

This upper dishrack roller is just over an inch in diameter and the axle that clips to the roller is an inch wide. It is all white in color and is made entirely of plastic. The upper roller allows you to move the dishrack easily on the support rails. No tools are required for this repair. This is a genuine OEM part.

Door spring linkage (door spring link)

The white door spring link goes between the door spring and the door hinge. This part provides more flexibility for the door spring. If the spring link is damaged or falling off it will need to be replaced. This is a genuine OEM part and made of plastic. It is sold individually.

Hose clamp

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Short dispenser door retaining pin (short hinge pin)

This dispenser door retaining pin is less than one inch long. Sold individually.

Hinge pin (hinge pin. 1 inch long.)

Sold individually. This part is exactly 1 inch long.

Inner door foam insulation strip (foam seal inside of door)

This inner door insulation seal is almost twenty-four inches long. It is gray in color and is made of a foam material.

Wax motor for detergent cup actuation (wax motor, dispenser actuation)

This wax motor is a little over two inches long. It is the rinse and detergent activator for some dishwashers.

Cabinet mount screw (screw)

Sold Individually - 2 screws needed to mount each handle.

Rinse aid knob (rinse-aid cap)

This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.

Screw (door screw)

Detergent cup lid spring (cup lid spring)

This detergent cup lid spring is half an inch long.

Lower wheel assembly (wheel assembly, lower)

This lower wheel assembly is all white in color, and is made of plastic. It is a little over an inch long, and a little over an inch in diameter. This wheel is used with a dishwasher's lower rack assembly.