DDW650WW-45 Parts List

Water inlet valve (dishwasher water inlet valve)

This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Impeller and seal kit (motor shaft seal and impeller kit)

This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.

Upper spray arm water supply hose (water supply hose, upper spray)

This is the replacement upper spray arm water supply hose for dishwasher. It is made of white plastic and has a connector piece on each end. This hose supplies water to the upper spray arm, so it can be sprayed onto your dishes when the dishwasher is running. The main reason to replace the supply hose is if it is cracked and leaking, and the spray arm is not getting enough water. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Detergent cup shaft and lever (shaft and lever for soap cup)

Cover is not included. Must order cover separately.

Detergent cup release arm

This is the replacement detergent cup release arm for your dishwasher. It is made of black plastic and is sold individually. The detergent cup release arm is found on the inside of the dishwasher door, and it is the part that releases both the detergent and the rinse-aid. If the rinse-aid and detergent are not being released during the dishwasher cycle, or you notice that the release arm is cracked or damaged, then you will need to replace it. A damaged detergent cup release arm can also lead to a door latch failure on your dishwasher, and it may cause the dishwasher not to start. This is an OEM part sourced directly from the manufacturer.

Detergent cup cover

Armature link (plunger and armature, drain solenoid)

Drain solenoid repair kit

This kit includes the armature and link assembly. You may need the solenoid bracket which is sold separately. This valve opens in order for the water to drain out of the dishwasher.

Detergent cup door spring (detergent door trip spring)

Hose clamp kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Screw

Size: 10-16 ab. * Part may differ in appearance, but functions same as original. Sold Individually.

Valve body gasket (gasket valve body)

Rinse aid injector container with gasket (tank rinse aid kit)

This part attaches to the inner door panel.

Heating element asm (heating element assembly)

This part is located at the bottom of the dishwasher and is not designed to heat the water that enters it. Rather, it's designed to maintain the heat of the water that enters the dishwasher.

Leveling leg

This leveling leg is located under the dishwasher cabinet. It is sold individually.