DGIJ Frigidaire Dryer Parts List

Door latch kit (dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.)

This door latch kit comes with the strike and the catch.

Flame sensor (flame sensor for gas dryer)

This part senses the flame for heat allowing the gas valve to open.

Igniter (gas dryer igniter)

This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.

High temperature adhesive (high temperature adhesive for installing rubber and felt seals)

The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.

Glide n' guard

Switch-door (dryer door switch)

Drum support roller (drum roller with plastic bearings kit)

This single drum support roller comes with plastic bearings and is made for some Frigidaire/WCI gas as well as electric clothes dryers.

Multi rib belt - 91" (dryer belt, length 91.20”, width 3/8”, characteristics, 4 ridges, flat)

This multi ribbed belt from Frigidaire/WCI is flat, but has four ridges. Manufacatured for Frigidaire/WCI brand clothes dryers, this belt is 91 inches in length and is 3/8 inch wide.

Switch-push start (dryer push to start switch)

Seal (drum rear felt seal with adhesive)

Elbow (4 inch 90 degree vent elbow)

5ft ucvent (universal connect flexable vent. 4" diameter extends to five feet.)

Close elbow c24 (90 degree close dryer vent elbow -uniquely designed elbow to allow close placement of dryer to the wall. Energy efficient metal construction for safe)

Wheel-blower (blower wheel assembly)

Lint screen (lint filter)

This dryer lint screen is used for Frigidaire/WCI brand electric and gas dryers. The filter is 13 inches wide and 8 inches high.