DLB2650WAL Hotpoint Dryer Parts List

Rear drum bearing kit (rear drum bearing kit. *bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum beari)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Lint filter with frame (dryer lint filter. This filter should be cleaned before every load to ensure proper airflow. If the lint filter is torn or damaged, replace it.)

The lint filter and frame for your dryer traps unwanted lint and debris so your dryer can effectively dry your clothes. If the old lint filter is cracked or clogged, or the dryer takes too long to dry or if excessive lint is accumulating inside the dryer or its venting, you may need to replace the lint filter. To replace the filter, simply remove the old, damaged filter, and replace it with the new one. This part is approximately 13 inches by 3 inches.

Rear drum bearing (rear dryer drum bearing. Be sure to enter your model number to ensure that you have the right bearing for your model.)

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

Front drum slide kit (front drum supports/glides (2), with hardware)

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

Heater 2-coil restring kit - 240v (heating element kit, includes two coils and hardware, 240 volts)

This restring coil kit is used to replace the existing coil in a dryer's heating element.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

High limit thermostat (high limit thermostat, l258-50f)

With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)

Multi rib belt - 4 ridges (dryer belt, length 99 1/8”, width 3/8”, characteristics, 4 ridges, flat)

This dryer drum belt goes around the dryer drum and the pulleys to rotate the drum once motor is activate.

Heater coil restring kit - carries 250 volts (heating element kit, for 250 volt export models)

This heating element coil restring kit is intended for use with many of GE's brands of electric clothes dryers. It carries 250 volts, and includes two coils.

Rear bearing retaining bracket (rear bearing retainer plate)

Terminal block - 220 volts (terminal block for power cord, comes with no hardware)

Blower wheel

Discontinued (dryer door gasket)

Timer knob (chrome and clear) (knob&clip as)

This chrome and clear-colored timer knob from GE has a red indicator line, and comes with a clip. This knob is just over two inches in diameter and is used for many of GE's brands of clothes dryers and clothes washers. It also has a clear, see-through plastic skirt.

Discontinued (thermostat l140-20f)