DLB2700LC Hotpoint Dryer Parts List

Drive belt (dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time.)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Lint filter with frame (dryer lint filter. This filter should be cleaned before every load to ensure proper airflow. If the lint filter is torn or damaged, replace it.)

The lint filter and frame for your dryer traps unwanted lint and debris so your dryer can effectively dry your clothes. If the old lint filter is cracked or clogged, or the dryer takes too long to dry or if excessive lint is accumulating inside the dryer or its venting, you may need to replace the lint filter. To replace the filter, simply remove the old, damaged filter, and replace it with the new one. This part is approximately 13 inches by 3 inches.

Idler pulley wheel (idler pulley wheel with spacer and retainer clip)

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Heater 2-coil restring kit - 240v (heating element kit, includes two coils and hardware, 240 volts)

This restring coil kit is used to replace the existing coil in a dryer's heating element.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

High limit thermostat (high limit thermostat, l258-50f)

With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)

Blower wheel

Felt seal as (felt seal, front panel to blower housing)

Discontinued (front drum seal & ring)

Discontinued (rotary switch)

Latch & adpt