DLB2750PD Hotpoint Dryer Parts List

Drive belt (dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time.)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Idler pulley wheel (idler pulley wheel with spacer and retainer clip)

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Heater 2-coil restring kit - 240v (heating element kit, includes two coils and hardware, 240 volts)

This restring coil kit is used to replace the existing coil in a dryer's heating element.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

High limit thermostat (high limit thermostat, l258-50f)

With this high limit/safety thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. This element is meant as a safety device, will kick back in when the temperature drops to 210 degrees Fahrenheit. (Limit: 260-50)

Door switch (dryer door switch, 3-wire. Use the two smaller terminals for models with only two wires to the switch (no drum light).)

This part has three terminals. Note: Use the two smaller terminals for models that only have two wires to the switch.

Start switch (motor centrifugal switch for "t" style motor)

Motor pulley with screws (motor pulley with set screw)

Heater coil restring kit - carries 250 volts (heating element kit, for 250 volt export models)

This heating element coil restring kit is intended for use with many of GE's brands of electric clothes dryers. It carries 250 volts, and includes two coils.

Discontinued (rotary switch)

Discontinued (motor centrifugal switch for "r" style motor)

Discontinued (timer assembly)

Discontinued