DLSR483EGW GE Dryer Parts List

Retainer o-ring (o ring)

This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-ring is made of rubber, and can occasionally wear down and break. If you notice that your dryer drum bearing is worn while you’re replacing the O-ring, you should consider replacing it as well. This product is sold individually, and is an OEM part from the manufacturer.

Door latch (dryer door catch kit)

This part helps to keep the door closed while the machine is running.

Door switch

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Cycling thermostat - 4 wire (cycling thermostat with bias heater, l210-30f)

This thermostat helps to regulate the dryer's internal temperature. L210-30F

Adjustable leveling screw (leveling leg, adjustable)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Nut (cap nut)

High limit thermostat - l315-65 (high-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element.)

This part is the replacement high-limit thermostat or safety thermostat for your dryer. The high-limit thermostat is found on the upper right-hand side of the heater housing, and it cuts off power to the dryer motor if the temperature reaches an unsafe level. If you push the start button and nothing happens, the high-limit thermostat should be tested for continuity and replaced if the contacts are open. Be sure to disconnect power to the dryer before you begin this repair. This part is sold individually and is an OEM part.

Blower wheel (blower wheel for dryer)

This wheel attaches to the motor.

Screw

Terminal block and grounding strap (terminal block and grounding strap for power cord)

This part is connected to the rear bulkhead of the dryer with screws. It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

Front panel assembly (dryer front panel, white)

Cycling thermostat (cycling thermostat with bias heater. On blower housing.)

This thermostat is located on the blower wheel.

Timer resistor

Screw

This screw is sold individually. Size: 10-16x1/2

Drum baffle

This is the replacement drum baffle for your dryer. It is made of black plastic and is approximately 14 inches by 4 inches. This part is sold individually and is an OEM part sourced directly from the manufacturer. The drum baffle is found inside the dryer drum, and it helps tumble your clothes. If the baffle is damaged or missing, you may notice marks being left on your clothes. The main reason you would replace the baffle is if you notice these marks, if the baffle is broken, or keeps falling off.