DV511AERXAA Samsung Dryer Parts List

Light bulb - 10w (light bulb, 10 watt.)

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Screw (screw 8 x 1/2)

This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.

Drive belt (dryer drum drive belt. This slender belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley.)

Idler pulley assembly (idler pulley and bracket for dryer drum belt)

Drum support roller & axle (dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is neede)

Sold individually.

Thermistor (dryer thermistor. If the dryer displays a fault code the thermistor may be defective.)

Drum assembly (dryer drum wrapper assembly)

Thermal fuse (dryer thermal fuse on heater housing (non-resettable). The original thermo-protector is riveted to the mounting bracket.)

Thermal fuse (dryer thermal fuse (also called the thermal limit). Located on the blower housing. The thermal fuse blows to cut off power to the dryer if the dryer o)

Thermal fuse with bracket (thermal fuse)

This part is the replacement thermal fuse for your dryer. When you order this part, you will receive the fuse itself, as well as the bracket that mounts it to the dryer. The thermal fuse is approximately 2 inches wide from end to end. It is a safety device inside the dryer that shorts out if the dryer overheats. When the fuse shorts out, the dryer will function properly. You can test your thermal fuse for continuity using a multimeter. Be sure to disconnect your dryer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Thermistor

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating.

Inlet hose - 5 ft (5-foot-long rubber fill hose for washing machines. Used for hot or cold water.)

This hose can handle hot or cold water and is five feet long.

Dryer leveling leg (leveling leg)

Leveling leg supports the dryer. Adjust the height of the leveling leg to make the dryer level.

Moisture sensor (dryer moisture sensor. The moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry.)

Assembly bracket thermostat (thermal fuse with bracket, located on the element housing. The fuse is not resettable and will need to be replaced if blown. If the dryer does not hea)