FFT6001-80A Parts List

Drive v-belt (washer drive belt. If this belt is broken, the washer will not spin or agitate.)

This drive belt is designed to ride on the pulley until the basket gets up to speed. If your washer drum will not agitate or spin, you may need to replace your belt. It is recommended to disconnect the power to your washer and shut off the water supply before you start your repair. This drive belt is a genuine OEM part.

Water inlet valve (water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine.)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Washer lid lock with external safety switch (lid lock with external safety switch)

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

Tension idler pulley (washing machine belt tension pulley assembly)

This idler arm assembly comes with the pulley wheel.

Spin bearing (upper spin bearing)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Direct drive pump (washing machine drain pump on top of motor)

This pump sucks the water out of your washers tub with one of its valves, and drains the water into a drain hose with the other valve.

Transmission assembly (transmission,service kit)

This part aids in the spinning or agitating cycles.

Snubber ring (snubber ring for tri-base)

Mounts at the base under the support.

Hose-drain (flexible drain hose)

Hub-drive (agitator drive hub)

Knob-timer (timer knob, black)

Stainless steel fillhoses c6 2pa (universal washing machine water supply hose set. Includes 2 extra strong 6 foot braided stainless steel hoses with hose washers already installed.)

Switch-pressure

Timer

Agitator la500a6 (agitator)