FFT6009-80B Parts List

Drive v-belt (washer drive belt. If this belt is broken, the washer will not spin or agitate.)

This drive belt is designed to ride on the pulley until the basket gets up to speed. If your washer drum will not agitate or spin, you may need to replace your belt. It is recommended to disconnect the power to your washer and shut off the water supply before you start your repair. This drive belt is a genuine OEM part.

Water inlet valve (water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine.)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Washer lid lock with external safety switch (lid lock with external safety switch)

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

Tension idler pulley (washing machine belt tension pulley assembly)

This idler arm assembly comes with the pulley wheel.

Spin bearing (upper spin bearing)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Lid strike - white (washing machine lid strike/actuator)

This part is used to activate the lid switch when the lid opens/closes.

Water inlet hose assembly

The water inlet hose assembly, also known as the fill hose, works in conjunction with your washer by supplying water to the tub during operation. The hose attaches to the water inlet valve and to the main top. If there is no water coming into the tub during the fill or rinse cycle, the hose may be damaged or clogged and will need to be replaced. This hose assembly measures approximately 19” long, is black in color and made of plastic. When replacing the hose please remember to reuse the clamp to secure the hose to the inlet valve and to connect the thermistor wires to the new hose. Disconnect the power and the water supply before beginning this repair. The water inlet hose assembly is a genuine OEM part.

Direct drive pump (washing machine drain pump on top of motor)

This pump sucks the water out of your washers tub with one of its valves, and drains the water into a drain hose with the other valve.

Transmission assembly (transmission,service kit)

This part aids in the spinning or agitating cycles.

Transmission to tub seal kit (washing machine tub seal kit, complete with instructions)

Splash cover seal (upper outer tub cover gasket)

Pulley (transmission drive pulley wheel)

Motor pulley (replacement motor pulley, washer)

This helps turn the pump and to help make the washer agitate properly. It is generally positioned between the motor and the pump.

Stud-agitator cap (agitator/cap bolt)

Hose-drain (flexible drain hose)