FFT6489B Frigidaire Washer Parts List

Screw-in plastic leveling leg (leveling leg)

Sold individually.

Water inlet valve (water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine.)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Trunnion (trunnion support for inner tub)

This part helps with the spinning and agitating cycles.

Spacer (timer shaft spacer)

This spacer goes between the timer knob and the dial.

V-style belt (washing machine belt, length 31 1/2”, width 1/2”, characteristics, medium “v”- shaped, cloth covering)

This washing machine v-shaped belt is cloth covered.

Snubber ring (snubber ring for tri-base)

Mounts at the base under the support.

Transmission assembly (washer replacement transmission kit. If the washer does not agitate, but the motor and belt engage the tranmission then the tranmission has likely fai)

This part aids in the spinning and agitating cycles. The length of the shaft on this part is 13". The seal/gaskets are NOT included.

Water temperature switch (water temperature selector switch)

Motor and drain pump assembly (drain pump and motor assembly)

Motor is 120 volts.

Hose-drain (flexible drain hose)

Cap-agitator (agitator cap and gasket)

Spring-horizontal (horizontal spring)

Pulley

Capacitor

Valve-check (check valve, drain)