GR-L288NTXP Parts List

Mullion spring (mullion spring for refrigerator door guide.)

This spring is located on the mullion, or door flap, of your fridge. This spring is sourced from the genuine OEM manufacturer for various refrigerator models. It measures about 1.5 inches in total length, and is made entirely out of metal.

Plate assembly,front (refrigerator door mullion.)

This is a replacement mullion rail for your French door-style refrigerator. You will typically find the mullion rail on the left side refrigerator door. The mullion rail helps to keep the refrigerator door closed. If the door will not close properly or if you notice leaking on your floor, you may need to replace the door mullion. A faulty mullion can gather moisture, resulting in a leak. To replace the mullion, simply disconnect the old mullion from the wire harness and unscrew it. Re-attach the wire harness to the mullion and screw it back into place.

Bottom door bin (door shelf bin)

The door bin is attached to the inside of the refrigerator door, and typically holds condiments, jars, and bottles. This OEM basket assembly is made of white and clear plastic. Measures approximately 16 inches long x 4 1/2 inches high x 5 inches deep. These parts should fit tightly to the door of your refrigerator, if yours is loose you should replace it immediately, as it could result in its contents spilling into the inside of your refrigerator, or onto the floor.

Water inlet valve assembly (primary and secondary water inlet valve assembly with wire harness)

This includes the primary and secondary valves along with the wire harness.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Evaporator fan motor

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Ice maker assembly - 3 wire (refrigerator icemaker assembly. Be aware the secondary or smaller wire connector has 3 wires in it. If original icemaker has a 6 wire connector see it)

NOTE: The Secondary (smaller) wire connector has 3 wires in it. If original ice maker has 6 wire connector see part number AEQ73110205. Please verify connector before ordering.

Refrigerator water reservoir (water tank)

The water reservoir holds the water for the water dispenser as the water chills.

Bucket assembly,ice

Light bulb (incandescent light)

Cap assembly,head (water filter bypass cap)

Fan assembly (evaporator fan blade)

Defrost sensor assembly (temperature sensing thermistor)

Switch,push button (push button switch)

Basket assembly,door (door shelf bin assembly)