GSD400Y GE Dishwasher Parts List

Rack slide end cap

This white rack track stop is used for your upper dishrack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.

Silverware basket (grey) (silverware basket)

This is a basket for washing flatware or silverware in your dishwasher. It is located on the lower rack. If your silverware basket is damaged or worn out, you should replace it. No tools are required for this repair. This basket is a genuine OEM part.

Drain valve shaft seal (dishwasher gate shaft seal)

The grate shaft seal, also known as drain valve shaft seal, is a seal for your dishwasher drain pump valve. The seal forms a watertight seal around the flapper valve shaft to avoid water from leaking on to the floor. The seal is black in color and measures .25” in diameter. When doing the repair, you may need to cut off the push-on nut, if so a new one will need to be ordered. Please remember to shut off the water supply and disconnect the power to the dishwasher before starting the repair. This is a genuine OEM part.

Motor and pump kit (unknown)

This pump and motor kit replaces many old style pump and motor kits that were manufactured since 1970. The instructions are included with this kit to help you to make it adaptable to your dishwasher. NOTE: This is a completely redesigned kit by the manufacturer and now includes the drain solenoid.

Push on nut (nut push on)

This push on nut is for your dishwasher or refrigerator. As the name suggests, it pushes into place, rather than being screwed in. It is approximately half an inch in diameter and is made of stainless steel.

Water inlet valve (valve water inlet)

This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Upper rack slide (rack slide)

This slide is mounted to each side of the upper cabinet wall. The dishrack wheels roll inside this track, which guides the upper rack.

Impeller and seal kit (unknown)

This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.

Drain hose (hose drain)

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.

Armature link (dishwasher drain solenoid link)

Drain solenoid repair kit (unknown)

This kit includes the armature and link assembly. You may need the solenoid bracket which is sold separately. This valve opens in order for the water to drain out of the dishwasher.

Hose clamp kit (clamp hose)

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Screw (dishwasher screw, #10-16 x 1/2-in)

Size: 10-16 ab. * Part may differ in appearance, but functions same as original. Sold Individually.

Lower spray tower kit (split ring seal)

Includes connecting boot and extendable spray tower.

Washer (washer st stl)