GSE25GGHNCBB GE Refrigerator Parts List

Humidity control - white (humidity control)

This part regulates the humidity of your crisper bins. It does so by opening and closing vents on the bin. If your humidity control is broken or missing, you will need to replace it. This is a genuine OEM part from GE and is sourced directly from the manufacturer.

Handle

Freezer door gasket - black (gasket door fz dg)

This door gasket is used to seal the freezer door when closed.

Micro switch (switch)

This is the replacement micro switch, or dispenser switch for your refrigerator. It is gray in color and measures approximately 1 inch by half an inch. The dispenser switch is what tells your refrigerator that it is ok to dispense ice or water. If your refrigerator is not dispensing ice or water, you may have a faulty or damaged switch. Be sure to disconnect the power to your refrigerator before you begin this repair. This switch is sold individually and is a genuine OEM replacement part sourced directly from the manufacturer.

Fresh food door gasket - black (gasket door ff dg)

This part is the replacement fresh food door gasket for your refrigerator. It is made of black rubber and is sold individually. The fresh food door gasket runs along the circumference of your refrigerator’s fresh food door and creates the seal that allows your refrigerator to regulate the temperature inside. If the gasket is worn, stretched, or damaged, your fridge may become too warm, and you may notice the door is sweating. The door also may not open or close properly because of a damaged gasket. To replace the gasket, carefully pull the old gasket out the grooves it fits in around the door. Press the new gasket into the same grooves snugly. This part is an OEM part from the manufacturer.

Refrigerator water filter (xwf retail filter)

This water filter is found in the rear upper-right corner of the interior of the refrigerator. If your model has a replacement indicator light it will turn red to signal the need for a replacement. If your model does not have an indicator light, the filter cartridge should be replaced every six months or earlier if you notice a decrease in the flow of water from the dispenser. The filter media is carbon black and reduces leads, some pharmaceuticals, and fifty other contaminates. It is 2 inches deep, 6 inches high, 2.25 inches wide and weighs approximately 1 lbs. When it comes time to replace the filter, first discard the old one by turning it to the left to remove. It will release itself when it has been turned far enough. Installation instructions are quick and simple but can vary slightly depending on if it is a bottom-freezer, side-by-side or multi-door bottom-freezer model. Refer to the user instructions for you filter. Do not forget to reset the filter change indicator if applicable. In bottom-freezer and side-by-side models this is done by pressing and holding the RESET WATER FILTER bottom for three seconds. On a multi-door bottom-freezer model, press the button underneath the Confirm Filter Change message while the water is dispensing. On select models this reset is done automatically once a new filter is installed.

Screw - 8-18 dg trt20 5/8 s (scr 8-18 dg trt20 5/8 s)

This genuine OEM screw is designed for use in refrigerators. It measures approximately ¾ of an inch in length.

Ice bucket & auger assm (bucket & auger asm)

Grommet / tube assembly (grommet and tube asm)

This is a replacement fill tube and grommet assembly for your refrigerator. This part acts your water line to your ice maker. If you’re noticing water in the back of the refrigerator or any kind of leak, or if your ice bucket isn’t filling up with as much ice, you may need to change out the fill tube and grommet assembly. When you purchase this part, you get the water line, as well as the fill tube and grommet. This is an OEM part sourced directly from the manufacturer.

Door bin ff adj

Armature kit (shroud solenoid)

Door stop - black (stop door black)

This part is the replacement door stop for your refrigerator. It is made of black plastic and is approximately 2 inches by 1 ½ inches in size. The door stop attaches to the bottom of the door and prevents it from swinging open and hitting the refrigerator cabinet. If your door opens too far, or opens with little resistance, it could be an indication that you need to replace the door stop. You will also want to replace the door stop if it is cracked, broken, or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Evaporator fan motor (motor dc evap fan asm)

Includes the wiring harness and thermistor. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Screw (screw 10-32 gxtt flp 595)

Size: 10-32 GXTT FLP .595 Sold individually.

Switch light fz (switch light)

3 terminal.