GUD27EESN0WW GE Washer Dryer Combo Parts List

Drive belt (belt drive)

This dryer drum drive belt is 89.5" long and has four ribs. This part helps spin the drum during the drying cycle.

Duct felt seal (felt trap duct)

The duct felt seal allows the front of the drum to glide smoothly on the exterior panel while the drum is rotating. The seal is located between the back of the drum and the rear dryer panel. If the heat is escaping from the drum area causing the dryer to run too long or if there are marks on your clothes you many need to replace the duct felt seal. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Drum bearing sleeve (sleeve drum)

Sold individually.

Interlock switch (switch interlock)

This switch is multi purpose, for a dishwasher the switch is a simple on/off mechanism that prohibits the appliance from operating when the door is open. For a dryer, this switch will let the dryer know if the belt breaks and shut power off to the dryer. If your dryer will not operate or your dishwasher will not start you may need to replace the switch. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Drum glide bearing - white (sold individually) (bearing slide)

Timer knob (knob main asm)

Retainer o-ring (o ring)

This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-ring is made of rubber, and can occasionally wear down and break. If you notice that your dryer drum bearing is worn while you’re replacing the O-ring, you should consider replacing it as well. This product is sold individually, and is an OEM part from the manufacturer.

Door latch (latch)

This part helps to keep the door closed while the machine is running.

Door switch

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Lid lock & switch assembly (lock lid)

The door latch lid lock is to lock the door on your washer when the appliance is in use. Your washer will not start if your door is not locked. If your latch is broken, you may not be able to start a cycle or open your washer door. It is mostly black in color and made of plastic. This part measures approximately 3.75 by 3.5 inches.

Door handle (handle door)

Cycling thermostat - 4 wire (thermostat bias ctr inlt)

This thermostat helps to regulate the dryer's internal temperature. L210-30F

Door strike (strike door)

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the door will not lock properly and not only will this cause the door to swing open, but it won’t allow the dryer to start properly. It is a small piece of metal, about 1 inch in length and is sold individually.

Complete duct trap assembly (trap duct / front seal)

Cycling thermostat (t'stat outlet ctrl)

This thermostat is located on the blower wheel.