GUD27GSSJ1WW GE Washer Dryer Combo Parts List

Drive belt (belt drive)

This dryer drum drive belt is 89.5" long and has four ribs. This part helps spin the drum during the drying cycle.

Duct felt seal (felt trap duct)

The duct felt seal allows the front of the drum to glide smoothly on the exterior panel while the drum is rotating. The seal is located between the back of the drum and the rear dryer panel. If the heat is escaping from the drum area causing the dryer to run too long or if there are marks on your clothes you many need to replace the duct felt seal. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Push-to-start switch (switch pts)

This switch is used to activate the dryer.

Drum bearing slide (bearing slide)

This OEM replacement dryer slide bearing is white in color, and approximately 3 inches long. The slide bearings are supportive linings for your dryer. If they have eroded, or are damaged, the drums will scrape against metal during the drying cycle which will produce a squealing, or scraping sound.

Interlock switch (switch interlock)

This switch is multi purpose, for a dishwasher the switch is a simple on/off mechanism that prohibits the appliance from operating when the door is open. For a dryer, this switch will let the dryer know if the belt breaks and shut power off to the dryer. If your dryer will not operate or your dishwasher will not start you may need to replace the switch. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Drum glide bearing - white (sold individually) (bearing slide)

Top bearing

Note: The drum slides should also be replaced when your replacing the drum bearing. Slides are NOT included. This part helps your dryer operate as quietly as possible.

Door latch (latch)

This part helps to keep the door closed while the machine is running.

Door switch

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Lid lock & switch assembly (lock lid)

The door latch lid lock is to lock the door on your washer when the appliance is in use. Your washer will not start if your door is not locked. If your latch is broken, you may not be able to start a cycle or open your washer door. It is mostly black in color and made of plastic. This part measures approximately 3.75 by 3.5 inches.

Door handle (handle door)

Hub nut (nut hub)

This hub nut is a genuine OEM replacement part for your stackable washing machine. Removing the hub nut may require a spanner wrench, as per the manufacturer specifications. Replacing this part requires some disassembly of the agitator assembly. The nut should be turned clockwise to remove it.

Igniter

NOTE: Be very careful to not handle the igniter by its gray part as it's very fragile. Hold it by its white tip only.

Tub seal (seal tub)

The tub seal is manufactured to create a watertight seal between the tub and the inner spin basket. Your seal will wear over time causing the rubber to dry out and crack, breaking the seal in your washer. You may need to replace this part if you notice leaking in your appliance. This part is about 2.75 inches in diameter, is made of rubber, and is black in color.

Cycling thermostat - 4 wire (thermostat bias ctr inlt)

This thermostat helps to regulate the dryer's internal temperature. L210-30F