JB500 GE Range Parts List

Bake element - 220v 2300w (bake unit 208/240v)

This closed-hinged style bottom bake element is located on the bottom of the oven cavity to supply the heat for baking. This bake element has screw-on wire terminals is 18 1/4-inch wide and 14 1/2-inch deep to mounting flange and the terminal ends extend 2 1/2-inch past the flange. The element is 2300 watts and 20 volts. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.

Bake element - push on terminals - 240v (unit asm bake (2585w))

This bake element is found on the bottom of the oven.

Trim ring - 6 inch (chrome trim ring for 6-inch burner.)

This 6 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.

Infinite heat switch kit (switch, inf surface unit)

The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.

Trim ring - 8 inch (trim ring 8")

This 8 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.

Broil element (broil unit 208/240v)

The broil element is located on the roof of the oven cavity to supply heat for broiling. The depth of the screw-on terminals is 2-3/4 inches and they are 1-1/4 inches apart. The mounting bracket is not included with the element. If the element is no longer heating or it has shorted out, then you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Surface element - 8 inch - 2350w (surface unit, 8")

The 8” coil surface burner element is used to supply heat to the top of the range for cooking. This element carries 2350 watts, and due to an update by the manufacturer is now a 5-turn element. If the element is not providing heat, the switch or element might have gone bad and will need to be replaced. You can use a multimeter to test for continuity to see which part is defective. Please make sure the element is cool before replacing it. This is a genuine OEM surface burner element. Disconnect the power to the range or cooktop before starting the repair.

Surface element - 6 inch - 240v (surface unit, 6")

This Y-frame 6-inch surface element is a genuine OEM part. It has five turns, a metallic center medallion and carries 240 volts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair.

Temperature sensor (sensor asm)

The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.

Broil element

This broil element is found on the upper part of the oven cavity.

Oven rack

Sold individually.

Range surface element control switch - 6 inch - 1560 w (inf sw cntl 1500w)

This switch controls the small burner on a range/stove top.

Rear support (support rear)

This rear drawer support comes with the installation screw. This part has been redesigned. The new support inserts towards the rear of the drawer as opposed to the side.

Terminal block (receptacle asm)

This kit includes one ceramic block with 6" wire leads, 2 wire nuts and 2 heat shrink with mounting bracket.

Screw (screw st8-18x.500trbrni)