JES1039WJ Parts List

Primary door interlock switch (switch micro)

This interlock switch is located in the door latch.

Fuse

The line fuse, also known as a ceramic fuse, is used to protect your microwave when there is a power serge by shutting down the microwave to avoid damage. If your microwave has no heat, won’t turn on, or the touch pad is not working properly, you may need to replace the fuse. This part measures approximately 1.25” long and is sold individually. Please remember to disconnect power to the microwave before starting the repair. This is a genuine OEM part.

Microwave magnetron (magnetron)

Genuine OEM magnetron for your microwave. Always use proper safety equipment and follow the manufacturers instructions while installing.

Switch,micro

The interlock door switch, also known as a micro switch, will prevent the microwave from operating if the door is open. This switch has been updated by the manufacturer. It may appear different in appearance but will still function as the original part. This part has a green button and measures approximately a little over an inch long. This is a genuine OEM part. Please remember to disconnect the power to the microwave before starting the repair.

Fuse,time delay (fuse time delay)

This line fuse protects the microwave by shutting down if there is an electrical surge. If your microwave is not turning on, you may need to replace the fuse. This part is just over an inch long, metallic on both ends and white ceramic in the middle. Please remember to disconnect power to your microwave before starting your repair. This is a genuine OEM part.

Switch,micro

This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.

Light bulb - 125v 20w (lamp)

This part is the replacement light bulb for your microwave. This bulb is 125 volts and 25 watts. It should come on automatically when you open your microwave door, or if the microwave is running. If your light bulb is burnt out, it will not be able to do this, and will need to be replaced. Before you change the bulb, be sure to check that the light socket still works, as it may need to be replaced as well. Remember to disconnect the microwave from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Screw,tapping

Rotating ring guide (rotating ring ass'y)

Magnetron

This part is used to generate microwave energy/heat.

Wave guide resin cover (wave guide - mica cover)

Turntable assembly

Single flame sensor (flame sensor)

Sold individually.

Lever

Board, latch (board,latch)