JVM1542BF Parts List

Damper (vent damper flap)

The vent damper is used to close off the exhaust duct when the fan is not running, to prevent outside air from entering the microwave. When the fan turns on it allows air to vent away from the microwave. The damper measures approximately 10-inch long by 3-inchwide and is a genuine OEM part.

Switch,micro

This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.

Charcoal filter

Sold individually.

Door latch (latch)

Used to keep the microwave door closed during operation.

Screw,tapping

Diode cable (h.V. Diode)

Damper

This vent damper is a manufacturer-approved replacement part for your above-range microwave. This part helps vent air from the microwave to the exterior of your home, and helps keep exterior wind out of the vent. Replacing the vent damper will require some disassembly of your microwave/ Unplug the unit before beginning work on it.

Magnetron

This part is used to generate microwave energy/heat.

Capacitor high voltage (capacitor,drawing[h.V])

Thermostat (thermostat- bimetal)

This part will trip once the inside of the cavity overheats and exceeds the recommended temperature.

Installation mounting hardware kit (hardware installation)

This kit contains all pieces required to mount a microwave to the wall. The mounting plate is sold separately.

Holder locker (latch body)

Turntable coupler (shaft- turn table)

Rivet

Diode (cable, assembly) (microwave diode assembly)