KV25G0XQ KitchenAid Cooking Parts List

Lower bearing (ring, attachment hub)

Used on Stand Mixers.

Bowl arm lift (arm, bowl lift)

This is a replacement bowl arm lift for your stand mixer. It raises and lowers the mixing arm in the bowl. It is made of white plastic and is sold individually. This part can also be known as the bowl lift arm adjusting bracket. This is an OEM part sourced directly from the manufacturer.

Wire whip

This part is the replacement wire whip for your stand mixer. It is made of metal and is approximately 7 inches from top to bottom, and 5 inches from side to side. The wire whip is an attachment which rotates and allows your stand mixer to whip items. The main reason to replace the wire whip is if your current whip is broken, or if your mixer does not currently have a wire whip attachment. This part is silver in color and is sold individually. It is an authentic OEM part.

Bowl retaining pin (pin, retaining bowl)

Used for Kitchenaid Stand Mixers.

Planetary - white (planetary assembly (white))

This part makes sure that all the ingredients are thoroughly mixed by moving the beater one way and the drive shaft another way. By doing this, the beater makes a circular path around the bowl and there is little need to scrape.

Gear (gear, internal)

Thumb screw - gray (thumb screw (storm gray))

Motor shaft seal (seal, motor shaft refer to page 2 color variation parts)

This part is the replacement motor shaft seal for your stand mixer. It is black in color and is approximately ½ inch in diameter. The motor shaft seal creates a seal between the shaft of the motor and the transmission housing. It helps to keep grease from seeping out from around the motor shaft. If you notice grease leaking past the motor shaft seal, then it will need to be replaced. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Stand mixer pinion gear (gear, pinion)

This pinion gear is a genuine OEM replacement part for your KitchenAid mixer. The pinion gear is located in the transmission housing and can become worn down over time. To complete this repair, you will need a pair of snap ring pliers to access the housing.

Coated flat beater (beater, flat (coated))

The Coated Flat Beater is an OEM accessory specifically designed for 5 and 6 Quart KitchenAid stand mixers. This flat beater is responsible for thoroughly incorporating ingredients when mixing or blending recipes.

Screw (screw, 8-32 x 5/8)

Sold individually.

Speed control board and knob (gray) (control assembly - grey knob)

Used with Stand Mixers. Knob is gray in color.

Fiber washer (washer, fiber)

Sold individually. This part goes on top of the planetary main shaft.

Planetary - empire red (planetary assembly (empire red))

Used with Stand Mixers

Washer (washer, shim)