Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.
This part includes the upper and lower air duct assembly and lint screen.
This spring retaining clip is used to hold the front panel onto the top of the washer. If your front panel is loose you might need to replace the clip. The clip is made entirely of metal and is used for some washing machines. This part is not quite an inch long and is sold individually. This is a genuine OEM part.
Part may differ in appearance, but functions same as original part.
This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.
This arm is what attaches to the idler pulley wheel.
This screw is sold individually.
Sold Individually.
At just two and a half inches, this metal spring fits onto the arm of the idler pulley assembly of gas and electric clothes dryers.
This kit contains two glide brackets and four screws.
This tapping screw is sold individually.
This cycling thermostat has a limit of 153 degrees Fahrenheit and a differential of 15 degrees. This means that with this thermostat, your dryer's heating element will cut out at 153 degrees Fahrenheit and cycle back on when the dryer's internal temperature drops by 15 degrees.
This pad is used for many clothes dryers. It is made of a felt material and it is a little over an inch long.
This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.
Sold individually.