LFXC24726M LG Refrigerator Parts List

Handle screw

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Door basket assembly (basket assembly)

Refrigerator door bin AAP73252202 is an original equipment manufacturer (OEM) part that fits some Kenmore Elite bottom-freezer refrigerators in the following series: 7957204, 7957205, 7957209, 7957218, 7957248, 7957311, 7957315, 7957401, 7957402, 7957404, 7957409, 7957504, 7957998 and 7957999. Also fits some LG bottom-freezer refrigerators in series LFX25991, LFX31925, LFX31935, LFX33975 and LMX31985. This door bin has an irregular shape?it's 13-1/2 inches wide, 9-1/2 inches deep on the left, 10-1/8 inches deep on the right and 4-1/4 inches tall. To install door bin AAP73252202, slide it into the door just above desired location and push down on the bin until it snaps into place.

Refrigerator water filter (filter assembly,water)

This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities that can cause ill-tasting water or an unpleasant smell. It reduces sediment, dirt, rust, limescale, sand, and many other contaminants that can be harmful to your health and the life of your appliance. This filter should be replaced every 6 months or 200 gallons to ensure top quality performance. To remove your unwanted filter, press the push button to open the filter cover (water may spill from the hole), pull out the old cartridge in a downward motion. To install the new filter, make it so the ears are in the horizontal position and push the new cartridge into the housing until it stops. Push the filter upward until it is secure. Click the cover to lock it in place. Run water for approximately 5 minutes to prep the filter for use, and discard water. Reset the “filter reset” button if applicable.

Basket assembly,door (door shelf bin)

Tray assembly, vegetable

Refrigerator ice maker

The ice maker includes the ice mold and the control device. The ice maker receives water from the water inlet valve and then holds the water in the ice mold until the water freezes solid.

Gasket,door

Freezer door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the freezer compartment.

Gasket assembly,door

Tray assm , vegetable

Water inlet valve

Switch,micro

Compressor (lf)

This part must be installed by a licensed and trained LG technician that is able to perform a software update, which is required for the installation of this compressor. Part number CJT30000002 is needed to perform the update. Also, the three pins on the side of the new compressor may be oriented differently than the original. If different, when installing the new compressor the compressor electrical connector must be rotated 45 degrees counter-clockwise.

Refrigerator ice container assembly

Shelf,glass

Fan assembly