Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
This part helps stop the washer from overflowing.
This hose can handle hot or cold water and is five feet long.
This triangular main tub bearing assembly is five inches long. It is made of metal.
This valve has two ports for water to enter. This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.
This kit comes with hub, seal head, gasket, seal shroud, seal seat, screw, spline insert, drive bell and seal.
Found at the end of the inlet hoses.
Bearing only.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This washing machine drive bell and seal kit comes with a seal, a plug, a shoulder screw, a drive bell, and some grease.
This pad is used for the levelling legs of many washing machines.
These springs are sold individually and usually require a total of 7 per appliance.
This two speed motor performs1725 revolutions per minute in one speed, and 1140 RPM in the other speed. It runs at 1/2 horsepower and carries 115 volts. This two speed motor has only one pulley.
This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.
A dryer's idler pulley wheel serves to help the belt to rotate the drum.
This hose is almost 5 feet long and now comes with the washers for proper installation. It is used to bring water into your washer for the cycles.