MDB4949SDH3 Dishwasher Parts List

Seal (dishwasher tub gasket)

This seal is attached to the inner cabinet to reduce noise.

Drain hose (dishwasher drain hose)

This part is used to drain water from your dishwasher.

Drain hose (dishwasher drain hose)

This drain hose is 6 and 1/2 feet.

Tub wheel (dishwasher dishrack wheel)

When you order this part it is recommended that you order the gaskets as well - search by model#.

Cover screw (range screw)

Sold individually.

Water inlet valve (dishwasher water inlet valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Spray paint - 12 oz. - white (appliance spray paint (white))

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Door spring (dishwasher door spring)

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

Push-in retainer clip

Sold individually.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Inlet fill hose (dishwasher water inlet tubing)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Door latch - black (dishwasher door latch)

Dishrack (dishwasher dishrack, lower)

This dishrack is for dishwashers. Dishrack holds the dishes in place during the dishwashing cycle. Follow the instructions in the manual when installing this part.

Manifold (mv-manifold)

This part is the replacement manifold for your dishwasher. It is made of gray plastic and is approximately 13 inches long and 3 inches wide. The manifold protrudes from the tub wall and connects to the middle spray arm. If the manifold is damaged, the spray arm will not be able to wash the dishes in the dishwasher evenly. If you notice that your dishwasher is not cleaning the way it should, it is an indication that you should check the manifold for damage. This part is an authentic OEM part sourced directly from the manufacturer and it is sold individually.

Upper spray arm (dishwasher spray arm)

The upper spray arm rotates and sprays water to clean the dishes inside the dishwasher tub. If your dishes are not being cleaned properly, you should check if there is an issue with the spray arm. To check your spray arm, make sure the spray arms can move evenly and freely on their bearing rings and mounting brackets. Remove your spray arm and check to ensure they are straight and undamaged. This spray arm is made of high-quality plastic and is just over 5 inches long.